moodLearning Wiki

This is an old revision of the document!


Raspberry Pi 3 Startup/Shutdown Button

_ Using TTP223 Jog Capacitive Touch Switch, a startup/shutdown button can be mounted on Raspberry Pi 3. Using jumpers, connect GPIO pins 5 and 6 to the ports indicated in the diagram below. The red wire (3V power) to Pin 1 or to Pin 17. If Pins 5 and 6 (Ground) are tight because of some other connections, the alternative is put Ground to either Port 9 or 14.

_

Just touch this side of the touch switch to shut down or turn on the Raspberry microcomputer.
_