Differences
This shows you the differences between two versions of the page.
| Both sides previous revision
Previous revision
|
Next revision
Both sides next revision
|
technical-notes-library-in-a-box [2018/12/31 12:05]
serbizadmin [Maintenance] |
technical-notes-library-in-a-box [2019/02/09 09:21]
serbizadmin [Maintenance] |
| * {{ ::raspbibetawithfan.jpg?100|}} IF you have a eLib Box version with a fan that draws its power from the Raspberry Pi board, notice to which pins fan wires are attached to and the colors (red and black) of the wire. Red on Pin 4 (5v power); black on Pin 6 (ground). Just in case the wires get detached from the board, just put them back in. If the fan itself breaks, don't worry too much about it. Just keep it there until you find a suitable replacement. | * {{ ::raspbibetawithfan.jpg?100|}} IF you have a eLib Box version with a fan that draws its power from the Raspberry Pi board, notice to which pins fan wires are attached to and the colors (red and black) of the wire. Red on Pin 4 (5v power); black on Pin 6 (ground). Just in case the wires get detached from the board, just put them back in. If the fan itself breaks, don't worry too much about it. Just keep it there until you find a suitable replacement. |
| {{ ::raspberry-pi-gpio-layout-model-b-plus-rotated-2700x900.png?400 |}} | {{ ::raspberry-pi-gpio-layout-model-b-plus-rotated-2700x900.png?400 |}} |
| | \\ |
| | \\ |
| | * If you're concerned with possible corruption of data if you just yank the power supply with properly shutting, a start/shutdown button may be added to a contraption. See [[raspberry-pi-3-startup-shutdown-button|this rig]]. |
| \\ | \\ |
| \\ | \\ |