moodLearning Wiki

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
technical-notes-library-in-a-box [2018/12/31 12:02]
serbizadmin [Maintenance]
technical-notes-library-in-a-box [2018/12/31 12:05]
serbizadmin [Maintenance]
Line 91: Line 91:
   * {{ ::heatsink.png?80|}}Over time, the heatsink could detach, as its adhesive would dry up. In this case, just remove the heatsink from the box to prevent it from short-circuiting the microcomputer board. The alternative is to use some double-sided, heat-transfering adhesive tape to re-attach the heatsinks. Remember to wipe the surface first before mounting the heatsink.   * {{ ::heatsink.png?80|}}Over time, the heatsink could detach, as its adhesive would dry up. In this case, just remove the heatsink from the box to prevent it from short-circuiting the microcomputer board. The alternative is to use some double-sided, heat-transfering adhesive tape to re-attach the heatsinks. Remember to wipe the surface first before mounting the heatsink.
   * {{ ::raspbibetawithfan.jpg?100|}} IF you have a eLib Box version with a fan that draws its power from the Raspberry Pi board, notice to which pins fan wires are attached to and the colors (red and black) of the wire. Red on Pin 4 (5v power); black on Pin 6 (ground). Just in case the wires get detached from the board, just put them back in. If the fan itself breaks, don't worry too much about it. Just keep it there until you find a suitable replacement.   * {{ ::raspbibetawithfan.jpg?100|}} IF you have a eLib Box version with a fan that draws its power from the Raspberry Pi board, notice to which pins fan wires are attached to and the colors (red and black) of the wire. Red on Pin 4 (5v power); black on Pin 6 (ground). Just in case the wires get detached from the board, just put them back in. If the fan itself breaks, don't worry too much about it. Just keep it there until you find a suitable replacement.
 +{{ ::raspberry-pi-gpio-layout-model-b-plus-rotated-2700x900.png?400 |}}
 \\ \\
 \\ \\